[SWITCH] Animal Crossing: New Horizons - "9:00 PM" by Sidon327

[Sidon327]

I think I got all those taken care of. As far as the bass in m.38, I removed the grace note for now, as it's pretty hard to emulate the bass slide sound, however I'm open to any ideas for that particular part!

Thanks!

[Latios212]

Cool! Last few things to polish up:
- The slur and staccato are clashing in m. 7/25/45/63/83/101
- Slur can be flattened a bit in m. 16/54/92
- Make sure the 2's around the duplets have enough space and aren't too close to the staccato - m. 78 (actually you can just put the staccato above the notehead here), 85, 103.
- Beat 4 misaligned in m. 103 LH

- Subsequent page headers are too high

They're at the correct height now, but the music is too close to the headers slightly reduce the space between systems and move them down to give the header more breathing room - the spacing will look more natural.

As far as the bass in m.38, I removed the grace note for now, as it's pretty hard to emulate the bass slide sound, however I'm open to any ideas for that particular part!

Yeah, I think this is fine as a single note but I think it would make more sense as a Fn since that's what it starts on and sustains for at least a beat. What do you think?

[Sidon327]

I made all those changes except for the space between the systems. For some reason every time I try to change the system space for the score it messes up the formatting of the entire sheet and I'm not entirely sure why this is. Can you clarify how I should go about doing this? Thanks!

[Latios212]

Hm, I'm not sure what your issue is but I can recommend how I normally go about it:

First, using the Page Layout Tool, right click the box for a system and choose Edit Margins, then fiddle with these numbers to set the same margins for all of the systems after page 1:

values that seem to work for this sheet

You cannot view this attachment.

[close]

Then, if you need to make further small adjustments (based on if there's a lot of stuff above/below the staff for certain systems) you can use the Staff Tool to drag individual systems up and down:

Spoiler

You cannot view this attachment.

[close]

[Sidon327]

Thanks! Not sure why it was going wrong before but this worked out fine

[Latios212]

You're welcome! Looks good now, accepting

[Zeta]

This submission has been accepted by Latios212.

~Zeta, your friendly NSM-Bot